Products

MaxWax (with VCI)

ANOTHER EXCITING NEW PRODUCT

Corrosion Technologies Corporation, makers of CorrosionX, now brings you MaxWax. A unique, synthetic wax barrier coating that provides maximum protection of all metals. MaxWax is effective in temperatures ranging from -60° F (-50° C) to over 390°F (200°C). It dries to a smooth, non-tacky, waxy film that remains pliable throughout its full operating range. It is resilient and bends with any movement of the coated surface, will not crack under stress and maintains its protective coat intact.

FAST DRYING

MaxWax dries in 8 to 24 hours, depending on ambient temperature and humidity. It should be sprayed on to a film thickness of 2-3 mils for uncovered outdoor storage of equipment. Unlike usual wax coatings, MaxWax will not harden, crack or lose flexibility even is sub-zero temperatures. Its ultra-low viscosity allows it to penetrate between and around close-fitting components to prevent the incursion of corrosion-causing moisture, gases or chemicals.

What’s more, it is the only wax coating to contain a Vapour Corrosion Inhibitor (VCI) that provides added rust or corrosion protection when the product is applied to confined areas such as the inside of cabinets or other enclosures. This special vapour forms an invisible, monomolecular coating that extends protection even when the wax coating cannot reach or is not desired, such as on electrical switches or mechanisms.

CHARACTERISTICS

Non Toxic: MaxWax contains no chromates, nitrates or heavy-metal compounds.

Biodegradable: The product is organically-based and poses no waste disposal problems.

Concentrated: Excessive amounts of MaxWax are unnecessary, making it less expensive than other barrier coatings.

MaxWax conforms to MIL-C-16173D (Grades 1 & 2)

HOW TO USE

MaxWax can be used on machined, plated or other metal surfaces as well as over existing coatings/finishes. The product will outperform many traditional paints or coatings without any special surface preparation required, although removal of dirt, grease or loose rust is recommended. A light, uniform coat is best achieved by spraying at a distance of 10-12 inches from the surface to be treated. Allow 8-24 hours for complete drying.

TYPICAL APPLICATIONS

Apply to any metal surface where maximum protection is needed, such as:

• Pipe coating
• Trailers
• Machined parts
• Cleats/cleat bolts
• Chains and wire rope
• Cars, planes and boats
• Shipment of parts/components
• Hand tools
• Undercoating
• Hinges, locks
• Long-term parts storage
• Machined parts

REMOVAL

Should it be necessary to remove the product, simply apply mineral spirits and wipe away. Use solvents or mineral spirits to clean up tools and remove overspray.

If you’re not convinced it does everything we say, we'll refund your full purchase price, NO IF'S, AND'S or BUT'S!